Three methods of repairing lithium batteries

- Sep 16, 2019-

1. Use a clean eraser or other cleaning tool to gently wipe the metal contacts on the lithium battery and the metal contacts on the phone to help with charging and power lasting.

2. The old mobile phone lithium battery that uses the automatic shutdown will be wrapped tightly with plastic wrap. When wrapping, try to serve as much as possible. There are three layers inside and outside to ensure that the battery is under vacuum. Then, the three-layer newspaper on the outside of the plastic wrap is used to completely seal the lithium battery. After being placed in the freezer layer of the refrigerator, after 48 hours, the battery was taken out, and the six-layer paper film wrapped outside was removed one by one. The lithium battery was not swollen or deformed due to freezing. After cooling for a while, then charge.

3. Discharge the lithium battery that is nearly scrapped and recharge it to activate the battery. The specific method is: deep discharge of the mobile phone, by exhausting internal electrical energy, to achieve a deeper degree of recharging, which requires some unconventional methods. Connect the phone to a low-voltage small light bulb with a specific device, and the internal power of the battery will be transferred to the small light bulb until it is fully illuminated. “The mobile phone needs to slowly run out of power through a lower voltage. Under normal circumstances, if the mobile phone is connected below the rated voltage of 3.6 volts, it will automatically shut down.” After the battery is discharged, the rechargeable battery can be used again. Long time.